When logging in with mobile shell (mosh) sometimes in Ubuntu the locales will mismatch. This is easily fixed by using the following two commands:
# locale-gen "en_US.UTF-8"
# update-locale LC_ALL="en_US.UTF-8"Substitute the locale for the one you wish to use in both places and then run this. For Swedish locale use sv_SE.UTF-8 as an example.
Jo men det är härligt när kollektivtrafiken löper som den skall. När den inte gör det är det för jävligt snarare och i dag var en sådan dag. Det har tagit mig närmare 3 timmar från Kallhäll till Hammarby sjöstad och det gick till på följande sätt:
I normalfallet tar resan ca 50 minuter.
Jag tar nog bilen ett tag.
Remember you can always check the status of samba using the commands
# service smbd status # service nmbd status
I found that they where running and started as they should but still did not accept connections. The bind interfaces in my samba.conf file is the interfaces rather than the ip address but it does not seem to solve the problem. However restarting samba did solve the problem and I nailed it down to the ”Samba IP sensitivity problem”.
Samba really does not like when you use DHCP for the server and even if you set it up so that it always gets the same IP from the DHCP server it does not matter, Samba does not like it.
The simple solution to this is to add the two following lines to the last part of /etc/rc.local which is the script that runs last upon boot.
service smbd restart service nmbd restart
However, also changing your networking setup to fixed IP generally works well, this is in case you do not want to do that or can’t do that.
Another way would be to change it to the dhcp lease script so when the samba server gets a new lease, an automatic restart of the related daemons happen. However, that would also interrupt any service being served at the moment and break long file transfers or streams. I would therefore advice against it.
The best solution so far is to use a fixed IP. The above workaround is a kludge. You have been warned.
Den senaste uppdateringen till Android Ice Cream Sandwich 4.0.2 i kombination med senaste maps medförde också att många fick problem med Google Navigate.
Anledningen är en uppdatering av Android TTS (Text To Speech) och om man går in i menyn i telefonen och återställer språket till Engelska i stället för Spanska så fungerar det utmärkt igen.
Inställningar -> Språk och inmatning -> Test-till-tal-utdata
Tryck på inställningsknappen bredvid ”Google TTS Engine”, välj sedan ”språk” och till sist ”Engelska (USA)”.
Nu fungerar Google Navigate utmärkt igen.